POLYUREA

MultiFLEX

301

Best use – Chemical resistance

Applications

Coating
  • Truck bodies, trailers, dump trucks
  • Agricultural equipment, salt or sand spreaders
  • Garage floors, mechanical and industrial workshops
  • Surfaces requiring chemical resistance
  • Bridge pillars and docks
  • Mining applications
Sealing
  • Chemical reservoirs and water treatment basins
  • Waste oil ponds, paper mills and liquid manure pits

MultiFLEX

301

MultiFLEX 301 is a 100% pure high hardness elastomeric polyurea with high rigidity. It stands out in particular as a coating that is very resistant to corrosion and chemicals. This high performance coating can be used in many application areas and on most substrates such as concrete, wood and steel.

Physical properties

Properties Methods Results
Hardness (Shore A/D) ASTM D2240 60D
Tensile strength (psi) ASTM D638 3000
Abrasion resistance (mg) ASTM D4060 6.5
Elongation (%) ASTM D638 250
Glass transition D7028-07 -55°C
Tear strength (N/mm) ASTM D624 65

10-15 sec

Cure time

2-4 min

Dry to touch

1 h

Light traffic

12-24 h

Return to service*

30 min - 10 h

Recoat**

* Polyurea reaches its full maturity after a few weeks, varying according to the type of product and the different environmental conditions.
** If the time is exceeded, the use of a surface activator is necessary to apply another coat.

Characteristics

  • Increased resistance to chemicals, oils, solvents and wastewater
  • High tear resistance
  • High adhesion on a wide variety of surfaces
  • A non-stick surface that helps slip
  • High hardness and high tensile strength
  • Waterproof
  • Free from volatile organic compounds (VOCs)

100%

Solid by weight

1:1

Mix ratio A:B (by volume)

100%

Solid by volume

1 year

Shelf life

Equipment settings

Description Pression Temperature
Hoses Minimum 145 BAR | 2100 psi 65°C | 150°F
Part A 175 BAR | 2500 psi 70°C | 160°F
Part B 175 BAR | 2500 psi 65°C | 150°F

*The values indicated on this technical data sheet are based on tests produced under laboratory conditions. Equipment configurations as well as application conditions can produce deviations in the values of the final system. The user is responsible for the resulting performance and for ensuring that the product is what is needed for the application he intends to do with it. For best results, these settings should be used.

Surface preparation

Make sure you have a ready application surface free of dirt, dust, oil, grease or any other contaminant before you begin. A CSP-4 through CSP-5 surface profile is required for application to concrete to achieve the best possible adhesion, producing a profile equivalent to 60 grit sandpaper or coarser. In addition, make sure that the surface is dry and that the air temperature exceeds that of the dew point. If the product is applied to a concrete surface, a cure time of approximately 28 days is recommended for optimum adhesion. In some cases, the use of a primer may be necessary. Please see the MultiFLEX Application Guide for details on application, surface preparation and recommended thickness.

Available on demand

  • UV stabilization and resistance additives
  • Primers and surface activators
  • Adhesion additives
  • Solvents and cleaners
  • Surface varnish
  • Membrane protection products

Want to know more

about this product ?

Get in touch to learn more about our solutions.